The Flame Sensor Module can detect flames in the 760 – 1100 nanometer wavelength range. Small flames like a lighter flame can be detected at roughly 0.8m. The detection angle is roughly 60 degrees and the sensor is particularly sensitive to the flame spectrum.
An on-board LM393 op-amp is used as a comparator to adjust the sensitivity level. The sensor has a digital and analog output and sensitivity can be adjusted via the blue potentiometer.
This Flame Sensor Module is used to detect fire/flame source or other light sources of the wavelength in the range of 760nm – 1100 nm. It is based on the YG1006 sensor which is a high speed and high sensitive NPN silicon phototransistor. Due to its black epoxy, the sensor is sensitive to infrared radiation.
The sensor can be a great addition in a firefighting robot, it can be used as a robot eyes to find the fire source. When the sensor detects flame the Signal LED will light up and the D0 pin goes LOW.
The module has 2 outputs: Analogue, which gives a real-time voltage output signal on thermal resistance, and digital which allows temperature thresholds to be set via a potentiometer.
سمات :
- High Photo Sensitivity
- Fast Response Time
- Sensitivity adjustable
- Detects a flame or a light source of a wavelength in the range of 760nm-1100 nm.
- Detection range: up to 100 cm.
- Adjustable detection range.
- Detection angle about 60 degrees, it is sensitive to the flame spectrum.
- Comparator chip LM393 makes module readings stable.
- Operating voltage 3.3V-5V.
- Digital and Analog Output.
- Power indicator and digital switch output indicator.
الشحنة تحتوي :
1 x Flame Sensor Module
Tutorial :
Arduino Flame Sensor Interface
| جهد التشغيل (VDC) | 3.3 ~ 5 |
| Spectrum range | 760nm ~ 1100nm |
| Detection Angle(°) | 0 to 60 |
| درجة حرارة التشغيل (درجة مئوية) | -25 to 85 |
| الطول (مم) | 35.5 |
| العرض (مم) | 15.2 |
| الارتفاع (مم) | 14 |
| الوزن (جم) | 3 |
| وزن الشحنة | 0.005 كجم |
| أبعاد الشحنة | 5 × 5 × 3 cm |
