The MJE13001 is a common BJT NPN switching transistor that is found in lamp ballasts and (cheap) phone chargers because of its high breakdown voltage and current capacity. It comes both in an SMD SOT-89 variant and a TO-92 THT variant.
MJE13001 Pinout Description
| الرقم السري | اسم الدبوس | وصف |
| 1 | قاعدة | Current into this terminal controls conduction between the collector and emitter |
| 2 | جامع | Current flows into this terminal |
| 3 | باعث | Current flows out of this terminal |
الميزات والمواصفات
- 600V collector-emitter breakdown
- 200mA collector current
- Current gain of up to 70
- SOT-89 and TO-92 package
- Power dissipation 750mW (TO-92), 550mW (SOT-89)
ملحوظة: Complete technical details can be found in the MJE13001 ورقة البيانات linked at the end of this page.
Equivalent
APT13005D, MJE13007
How To Use MJE13001
The MJE13001 is an NPN bipolar transistor featuring a high breakdown voltage of 600V between the collector and emitter and a medium emitter current of 200mA. The high breakdown voltage and current-carrying capability make it particularly suited for low-power SMPS و lamp ballasts. It can also be used to switch loads at high voltages.
Since this is a الترانزستور الجهد العالي, it has a few differences when compared to a lower voltage transistor. The first is the high base-emitter voltage of up to 1.1V, instead of the usual 0.6V. This must be accounted for when designing the driving circuitry. The cut-off current is also relatively high – 200uA when there is no base-emitter bias. This might cause problems upstream, and should be taken into account. The storage time is specified as 1.5us, meaning the transistor takes at least 1.5us to turn off after being turned on. This can be mitigated to some extent by adding a capacitor parallel to the base resistor to quickly remove current from the transistor base.
التطبيقات
- Fluorescent lamp
- Electronic ballast
- Rectifier circuits
نموذج ثنائي الأبعاد والأبعاد
MJE13001 Datasheet
