Product Overview
RELIFE RL-440 20/80 Active Rosin Core Solder Wire 0.3mm 20g is a fine-diameter solder wire designed for electronics repair, mobile phone maintenance, circuit board work, and precision soldering tasks. With a 0.3mm wire diameter, this solder wire is especially useful when working on small pads, delicate tracks, compact electronic boards, and repair points that need accurate solder control.
The RELIFE RL-440 solder wire uses an active rosin core to improve wetting, solder spreading, and oxide film removal during soldering. This helps the solder flow more smoothly on clean solderable surfaces and supports brighter, more consistent solder joints. The 20/80 alloy ratio makes it a practical medium-temperature soldering wire for many repair and maintenance applications where controlled solder feeding is needed.
This spool has an approximate net weight of 20g, making it suitable for technicians, repair shops, electronics students, hobbyists, and workshop use. The compact reel is easy to store, carry, and use on the bench without taking much space. It is suitable for manual soldering with a temperature-controlled soldering iron and can be used for a wide range of electronics service tasks.
The 0.3mm diameter gives better control than thicker solder wire when soldering small components or working near fine pins. It helps reduce excess solder application and makes it easier to form clean solder joints in detailed repair work. For phone boards, small modules, sensors, connectors, repair jumpers, and electronic components, this wire gives the user better handling and more precise solder delivery.
For best soldering performance, clean the soldering area before use and make sure the surface is solderable. Use a suitable soldering iron tip and set the temperature according to the workpiece, component sensitivity, and technician preference. Feed the solder wire gently to the heated joint, not directly onto the iron tip only, so the solder can flow properly onto the pad and component terminal.
Because this wire has a 0.3mm diameter, it is recommended for accurate work where too much solder may cause bridges or messy joints. Use only the amount needed for the joint. After soldering, inspect the connection visually and clean the area if required by your repair process.
Admin1 (#289) –
{“action”:”status_change”,”payload”:{“from”:”new”,”to”:”draft”,”by”:”Admin1″},”time”:”2026-05-12 11:32:24″}
Admin1 (#289) –
{“action”:”status_change”,”payload”:{“from”:”draft”,”to”:”publish”,”by”:”Admin1″},”time”:”2026-06-12 20:45:19″}